Panel Configuration

• The M Series main board assembly has a 9 way D-type connector at the top right. This connects to the T, R terminals of the WebWayOne panel interface.
• 
  The physical connection details at the WebWay are as follows:
• Blue cable to T
• Red cable to R
• Yellow cable to RTN
• 
  Go to Engineer Level 2
• Option 5 Communications
•      Option 2 Digicom
•         Option 1 Comms Format
•             Set to Option 7 - Extended SIA level 3
•         Option 2 ARC No 1
•             Set telephone number to <01666111>
•     Back to Digicoms option 2
•         Option 3 for account numbers
•             Enter the Account Number 1 <_______>
•     Option 4 Dialling mode Should be set to - Consecutive -
•     Option 5, Options
•         Option 1 Restore signals select
•         Option 2 Fast Format <8FF Channels>
•     Back to Digicoms Option 2
•         Option 6 CID/SIA reports set to [Full]
• 
  Back to Engineer Level 2
•     Option 5 Communications
•         In Option 4 RS232 options
•             Ensure Option 1 - Select RS232 baud <38400>
•             And Option 2 - Select Remote Modem
• 
  Back to Go to Engineer Level 2
•     Option 5 Communications
•         Select Option 1 downloader
•             Enter Option 1 and Select Password <______>
  (same as configured in downloader application)
•             Enter Option 2 Select site ID <______> 
  (same as configured in downloader application)
• 
  Communications Option 5
•     Select Option 1 - Downloader
•     Set Option 3, Select access mode to - Unattended -
•     Set Option 4, Edit call No 1 to - BLANK -
•     Option 5 Modem Options ensure
•         Option 1 - Select rings to answer Option 1 is - Immediate -
•         Option 2 - Select baud rate - 1200 - (2400 if available)
• Finally exit Engineering/Full downpower of WebWay & Panel to establish electrical connection.

Remote Access Programming

• Go to ‘set up downloading’
• Select download by (WebWayOne)
• Select poll timeout <10>
• Select modem init timeout <060>
• Select rings to answer <1>
• Select comm. Tx timeout <030>
• Select ARMPC telephone number (not required)
• Select program PCs <1>
• Select modem telephone number (not required)
• Select signal alarms (No)
• Select signal faults (No)
• Select signal set/unset (No)
• Select signal access code (No)
• Select password (optional UDL password)
• Select redials <03>

• Select time out <00>
• Select stop on success (No)
• Select dial mode (retry same)
• Exit engineering mode and save the configuration

UDL information for this item can be found here: