WebWayWorld Logo 2018

 

Panel Connection - Serial

Manufacturer Menvier
Model Menvier TS Series
Version TS Series
Panel Firmware Range MIN v5:1
Cable required? Yes 05-0241
DCM or Serial Connection Serial
Panel Profile TS900
Panel Bus Connection TTL
Technical Notes When on menu 1 press ENTER to get to menu 2. Press A to remove any additional digits if accidentally entered.

Cable Connection

Panel SPT Colour
Pin out 8 TTL R Green Wire
Pin Out 7 TTL T Red Wire
Pin Out 2 RTN Blue Wire

Galaxy Panel Connections

Galaxy Panel Connections

SPT Connections

SPT Connections

TS 690 panel Configuration:

  • Engineer menu 2
  • C – Modem options
  • 1. Callback No 1 - 123456
  • Callback No 2 - No setting
  • .Callback No 3 - No setting
  • Password – This must match the password configured in the Downloader application account setup
  • Modem site No –This must match the site ID configured in the Downloader application account setup
  • Digi Programming
  • Telephone No 1 No setting
  • Telephone No 2 No setting
  • Account No 1 No setting
  • Account No 2 No setting
  • Reports 1 No setting
  • Reports 2 No setting
  • Set/Day No setting
  • Restore No setting
  • Digi Idle No setting

  • Select Mode (Direct Access)
  • Select test calls (No)
  • Exit Engineer Mode into Day Mode

TS 790/900/2200/2500 panel Configuration

  • Engineer menu 2-
  • C – Modem options
  • 1. Callback No 1 123456
  • callback No 2 No setting
  • Callback No 3 No setting
  • Modem site No- This must match the site ID configured in the Downloader application account setup
  • T Modem site No- This must match the site ID configured in the Downloader application account setup
  • Digi Programming-
  • Telephone No 1 <01234 567890> - any number not 123456
  • Telephone No 2 No setting required
  • Telephone No 3 No setting required
  • Account No 1
  • Account No 2 No setting required
  • Account No 3 No setting required
  • Reports to No 1 Set all reports on
  • Reports to No 2 Set all reports on
  • Reports to No 3 Set all reports on

  • Set/Day Set all reports on
  • Restore Set all reports on
  • Invert Set all reports on
  • Dialling mode Consecutive
  • Test call period Disabled
  • Digi output 1 is Line fault
  • Digi output 2 is Line fault
  • Extended format Full report
  • TOS calls are Disabled
  • Ring count is Instant

UDL information for this item can be found here:

Support

Knowledge Base

Panel Guides

Downloads

FAQs