Remote Manager set-up for Remote Servicing Suite (RSS) application
This UDL application uses a Modem interface to connect to Remote Manager (RM) and therefore a virtual com port (com0com) is needed between RSS and RM (see com0com set-up next).
Create a RSS UDL Session:
1. Run up Remote Manager.
2. Click on the [Sessions] menu item and select the [New] menu item. RM will display a new [Session Configuration] page.
3. Give the new session a name by entering a name in the [Session Name] edit box.
4. Then click on the [Session Type] drop down list box and select [Honeywell RSS-Modem-MCM]from the list.
5. Click on the [SSH Server 1 IP] edit box and enter the IP address of PC that is running the SSH Server and WebWayOne’s MCT application.
6. Click on the [Save] button. Click on the [Modify] button and the [Edit properties] button. The following form will be displayed.
7. Make sure the correct virtual COM port is selected and it should not be the same as what the RSS selects. Baud rate must be ‘ 1200’. Also make sure that [ Block client retry messages ] is selected and the words ‘ Ping Pong ’ is written in the corresponding [ Value ] field.
1. Make sure the pin links from left and right are as shown above.
1. Open up the Honeywell Communication Server
2. Click on menu [Settings
à Communications Configurator]
3. Enable the virtual COM port and make sure the [Dial Mode] is set to [Modem].
4. If the [Modem Group] does not have ‘WWO Remote Manager’ then click on the [Modem Groups] button and add a ‘WWO Remote Manager’ entry and then select it in the [Modem Group].
5. Click on the [OK] and the Communication Server will make the virtual COM port available to the RSS application.
RSS
1. Open up the Galaxy Remote Servicing Suite application and enter your user name and password. Click on [Site] and then on [Add New Site]. Once the following form will be displayed enter the site details.
2. Click on [Next >] until the ‘Remote Servicing Information’ form is displayed. Fill in the [Remote Telephone Number…] field with the WWOID of the SPT interfaced to the panel for this account. Select ‘Galaxy’ from the [Control Panel Type] list. The finish.
3. From the RSS list of accounts select the account created and use menu [OptionsàRemote Access] to open form to connect to site
.
4. If this is the first time, select menu [ConnectàSetup].
5. Once you have enabled the [Modem Group] and selected ‘WWO Remote Manager’ from the modem list, click on [OK].
6. Select menu [ConnectàDial] to begin the process to connect to the panel.