This UDL uses virtual serial ports as the communication interface to Remote Manager. Once you have created two serial ports virtually linked, the UDL must be configured to open one port and an Remote Manager session configured to open the other port for communications to be successful. The connection is handled by using the site ID as the phone number to dial.
Creating a Remote Manager Session
1) Click on the [Sessions] menu item and select the [New] menu item. RM will display a new [Session Configuration] page.
2) Give the new session a name by entering a name in the [Session Name] edit box.
3) Then click on the [Session Type] drop down list box and select HKC from the list.
4) Click on the [SSH Server 1 IP] edit box and enter the IP address of PC that is running the SSH Server and WebWayOne’s MCT application.
5) Click on the [Save] button. Click on the [Modify] button and the [Edit properties] button. The following form will be displayed.
You may need to change the COM port to one of the virtual serial ports you created and selected for Remote Manager to listen on. COM10 is the default port for all sessions using the serial interfaces.
Note: You can use the same virtual serial ports for all your different UDL connections, but if you wish to use more than one UDL at the same time, you must set the COM ports for each session to be different.
6) Click on the [Accept] button.
Setting up HKC’s SmartLink
Load UDL application.
1) Login
2) Make sure you enter the SPT’s account\site id into [Dial Up Number] field and that you select ‘Ring panel’ from the [Remote Call Style] list for each of the Customer sites you create.
3) Make sure the communications configuration is set up correctly. Right mouse click on the [Setup] button and set the ‘Modem’ settings as shown:
4) To connect to a panel, click on the [Go Online] button, then Select the [Modem] button.
