Remote Manager:

HKC SmartLink 7 & 700:This UDL uses virtual serial ports as the communication interface to the RM. Once you have created two serial ports virtually linked, the UDL must be configured to open one port and an RM session configured to open the other port for communications to be successful. The connection is handled by using the site ID as the phone number to dial.

Create an RM HKC  session:

1)Click on the [Sessions] menu item and select the [New] menu item. RM will display a new [Session Configuration] page.

Fig 1:

2)Give the new session a name by entering a name in the [Session Name] edit box.

3)Then click on the [Session Type] drop down list box and select HKC from the list.

4)Click on the [SSH Server 1 IP] edit box and enter the IP address of PC that is running the SSH Server and WebWayOne’s MCT application.

Fig 2:

5)Click on the [Save] button. Click on the [Modify] button and the [Edit properties] button. The following form will be displayed.

<v> </v>

Fig 3:

You may need to change the COM port to one of the virtual serial ports you created and selected for the RM to listen on. COM10 is the default port for all sessions using the serial interfaces.

Note: You can use the same virtual serial ports for all your different UDL connections, but if you wish to use more than one UDL at the same time, you must set the COM ports for each session to be different.

6)Click on the [Accept] button.

Setting up HKC’s SmartLink 700: 

Notes:

• com0com for SmartLink 700 requires a different configuration for communications to Remote Manager to work. Follow normal process of installing com0com and creating com pairs. No linkages need be changed, just use the default set-up.

• SmartLink 700 run only on Windows 7 and above.

• A standard modem driver needs to be created and linked to the virtual port opposite to Remote Managers port. This modem driver is what you get SmartLink 700 to select to communicate with Remote Manager.

How to create and install a standard modem driver in Windows7:

Go to Start->Control Panel->Phone and Modem. Select [Modems] tab.

Press the [Add...] button 

Tick the [Don't detect my modem] tick box and press the [Next] button.

Select the 'Standard 56000 bps Modem' from the [Models] list and press the [Next] button.

Select the com0com virtual port and press the [Next] and [Finish] button.

Configure Smartlink 700

Load up SmartLink 700.

For creating a new account, click on the red START NOW button.

Select [New blank installation] and press the [Next] button.

<v> </v>

Select the panel type and press the [Next] button.

In the [Remote Code] field, add the panels remote user access code (same as the SPT's HKC_CODE value).

In the [Connection Method] field, select 'Modem'.

In the [Select Modem] field, select the standard modem driver you created earlier.

In the [Connection Type] field, select 'Dial panel'.

In the [Phone Number] field, add the account number of the SPT.

Press [Next] to continue and then [Finish].