2) Give the new session a name by entering a name in the [Session Name] edit box.
3) Then click on the [Session Type] drop down list box and select Gardtec from the list.
4) Click on the [SSH Server 1 IP] edit box and enter the IP address of PC that is running the SSH Server and WebWayOne’s MCT application.
5) Click on the [Save] button. Click on the [Modify] button and the [Edit properties] button. The following form will be displayed.
You may need to change the COM port to one of the virtual serial ports you created and selected for the Remote Manager to listen on. COM10 is the default port for all sessions using the serial interfaces.
Note: You can use the same virtual serial ports for all your different UDL connections, but if you wish to use more than one UDL at the same time, you must set the COM ports for each session to be different.
6) Click on the [Accept] button.
Gardtec Remote (UDL)
1) Run up the Gardtec Remote UDL application.
2) Select the [File] menu and then the [Engineer Login] menu item.
3) Default [Name] is Gardtec, default [Password] is Gardtec.
4) Press [OK].
5) Select [Options] menu followed by [Modem Setup] menu item.
6) From the [Port] list, select one of the virtual com port pairs linked with Remote Manager.
7) Make sure [Direct connect] is NOT selected. Press OK.
8) Default [Name] is Gardtec, default [Password] is Gardtec.
9) Press [OK].
10) Select the [File] menu followed by the [New Account] menu item.
11) Fill in the details making sure of the following:
12) [Phone] is set with the SPT account number.
13) [Acct No] is set with the same number used to set the panels <site id code> as described above.<br>
14) [Password] is set with the same password used to set the panels <password> as described above.<br>
15) Select panel model from [Panel] list i.e. 600 for the GT600 and the version number in [Ver] i.e. 3.0 for the GT600.<br>
16) [Connection Mode] is set to Dedicated line.<br>
17) Press [OK].<br>
</password></site>
